If you want to do the Linksys Velop installation without the Linksys application, first connect the Velop device to the power source. After that, combine or join one of the nodes with the modem device. For this connection, you may use an ethernet cord. Make sure that the modem and Linksys Velop device must be turned on. In any case, if you fail to detect an internet connection, verify that all the cables are connected perfectly. After that, settle all the different Linksys Velop nodes at the different corners of your office and house. You must be sure that there is an active internet connection between each node and the WiFi gadget such as a laptop, computer, cell phone, etc. so that they work properly. 

The LEDs on each Linksys Velop node will blink solid blue when all the nodes have a perfect connection with each other. Now, connect the computer to the Linksys Velop network and then open the web browser on a WiFi-connected device. Later, fill in the IP address of Linksys in the address bar of the web browser. At the bottom or back of the Linksys Velop device you can see the IP address. Then, fill in all the details which are shown on the display page. Under the connectivity option tap on the CA setup option. In the end, consider all the display instructions to do Linksys Velop setup without app.